AUDAC DPA73 Manual do Utilizador

PROFESSIONAL AUDIO EQUIPMENT DPA73/153 Triple Channel Class-D Amplifier User Manual & Installation GuideDPA73/153 AUDAC

9 Connecting the Amplifier Input connections The input connections of the amplifier are performed using balanced XLR connectors. Every channel has a

102) Bridge mono Mode: In bridged mono mode, the power of both Satellite output channels (Left & Right) is merged to deliver double the power t

11Output connections The loudspeaker connections for every output channel are performed with a two pin Euro-Terminal block connector. On the Left si

122) Bridge mono Mode: When the amplifier is switched in bridge mode, there will be one single load connected to the amplifier outputs. This load s

13Block Diagram Chapter 4

14Additional Information Technical specifications Chapter 5 DPA73 DPA153 Performance Rated power (1 kHz, THD 1%) Satellite Stere

15Personal notes

AUDAC PROFESSIONAL AUDIO EQUIPMENT User Manual & Installation Guide  AUDAC http://www.audac.eu [email protected]

2 INTRODUCTION ...

3 Introduction This section briefly describes the possibilities of the DPA73/153 Class-D Power Amplifiers. he DPA series amplifiers are digital pow

4 Environment Do not place this unit in an enclosed environment such as a bookshelf or closet. Ensure that there is adequate ventilation to cool

5 Safety Requirements Always handle the unit with care. Only use a grounded socket outlet and a power cord with grounding plug to plug in the unit.

6 Overview front and rear panel Front panel overview Description 1. Power switch: By means of the power switch, the amplifier can be turned ON a

7 Rear panel overview Description 5. Power inlet: The mains power supply (100~240V AC / 50~60 Hz) has to be applied to this AC power inlet. T

8 7. Input connections: The input connections of the amplifier are performed using balanced XLR connectors. Every channel has an XLR input connector